rotax912uls carb

Note: You are posting in the 915is section.

The 912is and 915is Engines are fuel injected and do not have Carburetors or ANY place to attach a Choke cable.

The fuel injected engine have throttle bodies and the cable need to be snugged up firmly.

I have never thought about putting a torque wrench to that bolt but 36 in∙lbs is what is in the installation manual.

See Section 73-00-00, Page 15 for all you need to know.

Thank you for your answer. As you pointed out,my engine is ROTAX912USL. In this case should I tighten throttle wire to valve lever 36 in-lbs?

(thread moved to 912/914 section)...

Just to be clear, you are asking about tightening the nut/bolt that attaches the cable to the throttle arm, right?

Once again, All the questions can be answered by refering to the 912ULS Installation Manual.

See Section 73-00-00, Chapter 2.2, Page 15.

Excerpt: 
Tightening Torque = 4 Nm (3.32 lb ft) (Suitable for 1.5 mm (.06 in.) Steel wire).  (<---<<<  ERROR!)

 - - -

ADMIN !!!

The 912is Manual is Correct.

The 912ULS Manual Incorrectly converted 4 Nm to 3.32 Lb∙ft .... 4 Nm = 2.95 lb∙ft. = 35.4 in∙lb