fbpx
Login

 

Jump to Forum..

Question of needle cup

in 2 Stroke Technical Questions 12 years ago
Hello,I just dissambly my bing carburator,Its my first time so I realized that the needle cup is brokken foward the hole that insert the needle. Its that correct.
Thank

  • Re: Question of needle cup

    by » 12 years ago

    Agustin,

    There should be no breaks in that plastic spring cup. Depending on where the break is, it could cause problems such as pinching the rubber O ring on the needle or causing the cup to not slide into the carb piston properly.

    Bill.
      
    Report

  • Re: Question of needle cup

    by » 12 years ago

    Thank for your reply, but I dont said the Plastic, I Said the needle CLIP, I made a mistake.
    this niddle clip, is brokenn foward the hole.
    Is that correct
      
    Report

  • Re: Question of needle cup

    by » 12 years ago

    agustin,

    I think I understand now. The needle clip is split through hole that the needle fits in. This allows the clip to open enough to change needles or needle clip positions. Always be careful when changing needles or clip positions. If you open the clip too far, it can remain open and fit loosly around the needle. This loose fit is the reason that the small O ring is on the top of the clip. The O ring prevents the needle from spinning or vibrating in the clip and wearing out. A proper clip will have a straight split through the center of the hole that holds the needle.

    Bill.
      
    Report

  • Re: Question of needle cup

    by » 12 years ago

    Agustin,

    If I remember correctly, the clip may have rounded edges at the forward end of the split to make it easier to insert or remove the needle.

    Bill.
      
    Report

  • Re: Question of needle cup

    by » 12 years ago

    Bill, Thanks for you reply, I have two photos to see de needle clip. foward de hole, it have a break line.
    thank again
    NeedleClip1.JPG (You do not have access to download this file.)
    NeedleClip2.JPG (You do not have access to download this file.)
      
    Report
You do not have permissions to reply to this topic.
Related Topics
Title Category Replies
Engine Registration Questions General Tech Discussion 1
engine identification question General Tech Discussion 4
261704 vs 261705 needle 2 Stroke Technical Questions 0
Inflight adjustable prop questions General Tech Discussion 3
912 ULS Crankshaft Nut Torque Question 912 / 914 Technical Questions 12
Follow Us

Recent Videos

Safety First!

 

To receive critical-to-safety information on your ROTAX Engine, please subscribe to
ROTAX-OWNER.COM

Prize Giveaway!


SUBSCRIBE NOW
to automatically enter this years draw!

Login