Fuel return using banjo bolt and restriction jet

by Roger Isabelle in 912 / 914 Technical Questions 9 years ago

I'm installing a return line from the carbs using the rotax banjo bolt with the restriction jet can i just T into the gascolator line or do I have to go straight to the tank thanks for any replies Roger
rogerisabelle1@gmail.com

Page 1 of 2

Start
Prev
1
2
Next
End

Re: Fuel return using banjo bolt and restriction jet

by Alan Arnold » 9 years ago

Alan Arnold

20 188 145

Hi Roger.

Since I don't have a gascolator, I teed into the fuel supply line prior to my fuel filter just after it passed through the fire wall. It has worked for a couple years and a hundred hours or. Any air bubbles will vent through the carb bowl vents.

These are my results; yours may vary. :-)

Alan

Thank you said by: Roger Isabelle

Report
Re: Fuel return using banjo bolt and restriction jet

by Roger Lee » 9 years ago

Roger Lee

128 5.28k 4.98k

Owners have teed this in a couple of places, but the inlet side of the gascolator is a good place. It will recirculate that into cooler fuel and prior to the filter in the gascolator. My Flight Design CT is teed into the top of the gascolator.

Roger Lee
LSRM-A & Rotax Instructor & Rotax IRC
Tucson, AZ Ryan Airfield (KRYN)
520-349-7056 Cell

Report
Re: Fuel return using banjo bolt and restriction jet

by Roger Isabelle » 9 years ago

Roger Isabelle

5 5 0

the top of the gascolator is what I was thinking I dont have enough room to T off on the bottom thanks for the replies this forum is a great place to get answers thanks again ROGER

Report
Re: Fuel return using banjo bolt and restriction jet

by Roger Lee » 9 years ago

Roger Lee

128 5.28k 4.98k

That's where mine returns to. The top of the gascolator.

Roger Lee
LSRM-A & Rotax Instructor & Rotax IRC
Tucson, AZ Ryan Airfield (KRYN)
520-349-7056 Cell

Report
Re: Fuel return using banjo bolt and restriction jet

by Damien Graham » 9 years ago

Damien Graham

9 9 0

I have a Zodiac 601 HDS. We are installing leading edge wing tanks and a Rotax 912ULS. Each wing tank will have a facet fuel pump. Could we also send the return line to the top of the gascolator with this set up, even though the fuel will be pressurized? Thanks.

Report

Page 1 of 2

Start
Prev
1
2
Next
End

You do not have permissions to reply to this topic.

Title	Category	Replies
Rotax fuel pressure sensor 664365 in Garmin G3X GDU460	915iS Technical Questions	0
Electrical Fuel Pumps	General Tech Discussion	0
916 fuel pump alternatives	916iS Technical Questions	7
914 Fuel Pressure/Prop Pitch	912 / 914 Technical Questions	2
Fuel pump setup?	912 / 914 Technical Questions	3

Fuel return using banjo bolt and restriction jet

Recent Videos

Safety First!

Prize Giveaway!

Log In/Out

Login