fbpx
Login

 

Jump to Forum..

EGTs getting cooler and uneven.

in 2 Stroke Technical Questions 12 years ago

  • Re: EGTs getting cooler and uneven.

    by » 12 years ago

    Hi Nick if you don't want to disturb the probes just swap the wires on the gauges.
      
    Report

  • Re: EGTs getting cooler and uneven.

    by » 12 years ago

    Hi guys...great minds think alike....I did intend to swap the wires on the back of the gauge as I was thinking its prob a wiring or gauge prob...but I found the prob before I did that,

    Only sorted it yesterday....my plan was to test the gauge with the ohm range on my multi tester...when I did both sides of the gauge they read the same....I as I was about to re fit the 4 wires back on the gauge one of the terminals fell off the end of the wire...when I first looked at the wiring they all looked ok....but this one had a heat shrink sleeve on it and I think the wire had broken or corroded under it and the heat shrink held it in place making it look as if nothing was wrong,

    The wire was prob only just touching the metal connector that pushes onto the pin on the back of the gauge,

    I gave it a good ground run yesterday and all is now fine...I have noticed when one wire is removed on a duel gauge it seems to effect its opposite side needle...hence why both where reading lower but one much lower,

    Thanks for you advice guys.

    Nick.
      
    Report

  • Re: EGTs getting cooler and uneven.

    by » 12 years ago

    Hi Nick,

    Glad you found the elusive electrical ghost that has from time to time given us all a tad of trouble with electrical issues.

    I usually tell most people when trouble shooting any electrical problems to always grab a wire and give it a gentle tug. Many times I have found wires that looked attached, but when you tug on them they pull right out or were held in by 1-2 strands and had a poor connection.

    Roger Lee
    LSRM-A & Rotax Instructor & Rotax IRC
    Tucson, AZ Ryan Airfield (KRYN)
    520-349-7056 Cell

      
    Report

  • Re: EGTs getting cooler and uneven.

    by » 12 years ago

    Wise words Roger....I will remember that tip.

    Nick.
      
    Report
You do not have permissions to reply to this topic.
Related Topics
Title Category Replies
Oil cooler 912 / 914 Technical Questions 2
Oil Coolers - New style vs old 912 / 914 Technical Questions 2
INTECOOLER 914 912 / 914 Technical Questions 0
Advice for getting the float bowl back on properly 912 / 914 Technical Questions 7
Do I need an Oil Cooler Thermostat? 912 / 914 Technical Questions 19
Follow Us

Recent Videos

Safety First!

 

To receive critical-to-safety information on your ROTAX Engine, please subscribe to
ROTAX-OWNER.COM

Prize Giveaway!


SUBSCRIBE NOW
to automatically enter this years draw!

Login