582 dual carb cable specs
in 2 Stroke Technical Questions
7 years ago
Greetings all! Forgive the question if the info exists elsewhere here on the forum but my efforts at searching failed to yield the answer I need. Essentially I am setting up a 582 on a Quicksilver MX rebuild and have new cables (carbs/oil pump) and am unable to get the carbs adjusted properly. I have enough throw, or travel, in the slides but it's not in the right place which leads me to believe the inner cable is not long enough. I have the adjustment barrels at top of carb run all the way down and the slides are open more than 5/16" at widest point but when full throttle slides are more than 1/4" above throat. The cables are new Aircraft Spruce long-reach system for the 582 (plugs up) with the carb cable housings 18" and 22". Could I perhaps have some cables that weren't made up properly? Are there published lengths for the inner cable? I'm not opposed to making up new inner cables if I have to. Well, actually I am when I should be able to get the proper assemblies off the shelf. But if I gotta then I gotta! If anyone has seen this issue or have suggestions please post up. Thank you!
582Closed.jpg (You do not have access to download this file.)
582Open.jpg (You do not have access to download this file.)
.png)
