Oil Pressure Plug Screw Torque M12X1

by Steve Halter in 912 / 914 Technical Questions 13 years ago

In the IPC manual , there are 2 specs for torque on the M12x1 Plug Screw. The first line says 18ft lbs and the next line says oiled-thread 11 ft lbs. Any thoughts?

Thanks

Re: Oil Pressure Plug Screw Torque M12X1

by bill martin » 13 years ago

bill martin

10 757 0

Steve,

Both specs are good. If the bolt and bolt hole are clean and dry, use the higher dry torque setting. If the bolt and/or hole are oiled, use the wet torque setting.

Bill.

Report
Re: Oil Pressure Plug Screw Torque M12X1

by Roger Lee » 13 years ago

Roger Lee

128 5.28k 4.98k

Hi Steve,

Bill's dead on the mark. Most nuts or bolts a dry torque specification. Those should never be torqued wet or with any lube on them to the dry torque specs unless you want to do repairs just for the fun of it. In this case Rotax gave the dry and wet torque values and they should be adhered to, to prevent any thread damage.

Roger Lee
LSRM-A & Rotax Instructor & Rotax IRC
Tucson, AZ Ryan Airfield (KRYN)
520-349-7056 Cell

Report
Re: Oil Pressure Plug Screw Torque M12X1

by Steve Halter » 13 years ago

Steve Halter

2 11 0

Thanks Guys,

I kinda thought thats what it meant, just wanted validation. I did torque it
to the lower setting when I did the work..

Report

You do not have permissions to reply to this topic.

Title	Category	Replies
Rotax fuel pressure sensor 664365 in Garmin G3X GDU460	915iS Technical Questions	0
Air Ingress at Oil Change	912 / 914 Technical Questions	1
Belly Oil	912 / 914 Technical Questions	7
What material is the oil tank lid made of?	912 / 914 Technical Questions	6
Oil line plug caps	General Tech Discussion	5

Oil Pressure Plug Screw Torque M12X1

Recent Videos

Safety First!

Prize Giveaway!

Log In/Out

Login