Rotax 912 carburetor maintenance/cleanig bing 64

by Gérard NOMMER in 912 / 914 Technical Questions 13 years ago

Hello
Please, can you describe me the recommended preventive maintenance/cleaning to do every month or two month depending on the flight frequency?
How often I have to do the carburetor synchronization?
Thanks
Gerard

Re: Rotax 912 carburetor maintenance/cleanig bing 64

by bill martin » 13 years ago

bill martin

10 757 0

Gerard,

Best place for this information is to go to the top of the page and click on the support tab, then the manual tab, then the 912 line maintenance manual. It describes all of the scheduled and unscheduled maintenance checks and how to do them.

Unless you are having a problem, disassembling the carbs is done every 200 hrs. or two years, whichever comes first. There is an annual or 100 hr check which does not require disassembly of carbs. Rubber parts should be replaced every five years regardless of hours.

Synchronization should be done at 100 hrs. or annually. I usually synchronize mine a couple of times a year but that's just a matter of personal preference.

Bill.

Thank you said by: Capt. Siva,

Report
Re: Rotax 912 carburetor maintenance/cleanig bing 64

by Capt. Siva, » 7 years ago

Capt. Siva,

25 266 738

kindly list down the rubber parts from carburetor that required tobe change after 05 years of time? like o.ring, diafram, float

Report
Re: Rotax 912 carburetor maintenance/cleanig bing 64

by Rob Seaton » 7 years ago

Rob Seaton

3 1.32k 251

See the rubber replacement list in the 912 Line Maintenance Manual chapter 05-10-00 section 2.1 page 8

Thank you said by: Capt. Siva,

Report
Re: Rotax 912 carburetor maintenance/cleanig bing 64

by Capt. Siva, » 7 years ago

Capt. Siva,

25 266 738

Thanksgiving.MR.ROB SEATON,
O.RING inside the carburetor is not mentioned.
so please guide me about o.ring inside the carburetor replacement?

Report
Re: Rotax 912 carburetor maintenance/cleanig bing 64

by Rob Seaton » 7 years ago

Rob Seaton

3 1.32k 251

Correct, o-rings are not on the list. if it is not on the list it does not have to be replaced.
The o-rings are replaced at the 200 hour carb inspection.

Report

You do not have permissions to reply to this topic.

Title	Category	Replies
912 ignition troubleshooting	912 / 914 Technical Questions	3
Rotax fuel pressure sensor 664365 in Garmin G3X GDU460	915iS Technical Questions	0
Seeking Advice on MAP and RPM Limits for Rotax 912ULS (Post-SB-912-079)	912 / 914 Technical Questions	2
912ULS Exhaust Spring Tension	912 / 914 Technical Questions	6
912 air filters replacement	912 / 914 Technical Questions	1

Rotax 912 carburetor maintenance/cleanig bing 64

Recent Videos

Safety First!

Prize Giveaway!

Log In/Out

Login