Dear friends:
Since I decided to put a Woodcomp Propeller (in flight) variable pitsh instead of my Warp Drive 3 blade propeller that produced heavy vibratios when puting less power in my Zenith Zodiac, I need to know how to take out a plug from the hollow shaft of my older 912 S engine (S/N 4.426.283).
This shaft has a plug inside and there is a plate to be taken out at the back end of it.
Engine is type 4 (hollow shaft), so it is thougt that user can install a driver rod trough it for operating a variabel pitsh propeller.
How or where can I get technical information for doing this job ?
Regards,
jorge
Since I decided to put a Woodcomp Propeller (in flight) variable pitsh instead of my Warp Drive 3 blade propeller that produced heavy vibratios when puting less power in my Zenith Zodiac, I need to know how to take out a plug from the hollow shaft of my older 912 S engine (S/N 4.426.283).
This shaft has a plug inside and there is a plate to be taken out at the back end of it.
Engine is type 4 (hollow shaft), so it is thougt that user can install a driver rod trough it for operating a variabel pitsh propeller.
How or where can I get technical information for doing this job ?
Regards,
jorge
