912 uls ignition problem

by wayne silvan in 912 / 914 Technical Questions 10 years ago

I bought a used 912 uls that came out of a wrecked aircraft and it is in good condition except that I cant get any spark at the plugs.The A module has the part number 05-0798 on it and I have another engine here that runs but the module number is 03-1671 can I interchange these to,if not where can I send them to get them checked?I also checked the voltage coming from the stator to the module and both of them are around 6 volts only at cranking speed,does this sound right? I was wondering if the flywheel might have some corrosion on it and might be the cause of not enough volts.Thanks

Re: 912 uls ignition problem

by Rob Seaton » 10 years ago

Rob Seaton

3 1.32k 251

Lockwood has a proper module tester.

Report
Re: 912 uls ignition problem

by Mark Taylor » 10 years ago

Mark Taylor

0 3 0

I had trouble with one side of my ignition. It was a loose power supply wire coming up from the stator to one of the ignition modules. It would work if I pulled up on the wire and then cut out when I layed the wire back down. It was where the wire connected right next to the module. There are a whole lot of connectors there all just a couple of inches from the box. Too many and too close. The leads should be different lengths from the box if you ask me.

Report
Re: 912 uls ignition problem

by wayne silvan » 10 years ago

wayne silvan

7 17 23

I found the problem it was the faulty start sequence on the modules cooled one of them off and it fired right up.After it started I did a mag check and found that the upper 2 4 cylinders on the b box were missing so began the hunt again well, it seems I was chasing somebody else's problem in the end,someone had it apart preveously and on the B 2-4 magnetic eye they had put it on the wrong side of the offset spacers so it wasn't getting read and of course no trip signal. I must say I will have to say my hat's off to Kevin at CPS for the help.

Report
Re: 912 uls ignition problem

by Kevin Kane » 10 years ago

Kevin Kane

1 32 24

Thanks Wayne, I'm glad I was able to help.

Report

You do not have permissions to reply to this topic.

Title	Category	Replies
912 ignition troubleshooting	912 / 914 Technical Questions	1
Seeking Advice on MAP and RPM Limits for Rotax 912ULS (Post-SB-912-079)	912 / 914 Technical Questions	2
912ULS Exhaust Spring Tension	912 / 914 Technical Questions	6
912 air filters replacement	912 / 914 Technical Questions	1
912 Smoke system	912iS Technical Questions	0

912 uls ignition problem

Recent Videos

Safety First!

Prize Giveaway!

Log In/Out

Login