Rotax RPM gauge and resistor

by Przemysław Wiśniewski in 912 / 914 Technical Questions 10 years ago

Hi. I changing engine instruments in my plane and I found that rotax standard RPM gauge is connected via resistor in line of RPM signal. Why someone put this resistor serial into rpm pickup? In rotax manual I can see that gauge is connected directly. Usually resistor in this place is used to avoid over measuring (if rpm signal and noise is to hight). But If oryginal gauge require this?

Re: Rotax RPM gauge and resistor

by Séamus King » 10 years ago

Séamus King

3 13 3

Przemyslaw,
I put the new style flywheel on my engine to make starting easier. On the first takeoff with the new flywheel the rpm indications went crazy above 5000 rpm. I installed the resistor on the RPM gauge as suggested by Conrad Beale and the problem was solved.

Shay.

Report
Re: Rotax RPM gauge and resistor

by Przemysław Wiśniewski » 10 years ago

Przemysław Wiśniewski

65 247 3

Now works fine without resistor. Anyway I found that my rpm clock shows to low RPM. I had to tune it by internal screw.

Report

You do not have permissions to reply to this topic.

Related Topics

Title	Category	Replies
Rotax fuel pressure sensor 664365 in Garmin G3X GDU460	915iS Technical Questions	0
Seeking Advice on MAP and RPM Limits for Rotax 912ULS (Post-SB-912-079)	912 / 914 Technical Questions	2
Rotax 916 Smoke System	916iS Technical Questions	1
912is rpm drop	912iS Technical Questions	22
Purchase rotax582 engine	Rotax-Owner Community	1

Rotax RPM gauge and resistor

Recent Videos

Safety First!

Prize Giveaway!

Log In/Out

Login