Tachometer Signal Characteristics

by Kyle S in 912 / 914 Technical Questions 7 years ago

I am working on a small engine monitor project which includes a tachometer. Can someone describe the characteristics of the tachometer signal from the 912? I am looking specifically for expected voltage ranges and distortions that I will need to filter. My engine is currently under overhaul so I can't get a scope on it.

Re: Tachometer Signal Characteristics

by Rob Seaton » 7 years ago

Rob Seaton

3 1.32k 251

see attachment

TachOscillogram.jpg (You do not have access to download this file.)

Thank you said by: Kyle S

Report
Re: Tachometer Signal Characteristics

by Kyle S » 7 years ago

Kyle S

10 5 8

Thanks that is exactly what I need. Do you know if there is an equivalent for the 582?

Report
Re: Tachometer Signal Characteristics

by Rob Seaton » 7 years ago

Rob Seaton

3 1.32k 251

I don't know, try posting that in the 2 stroke section

Report
Re: Tachometer Signal Characteristics

by Kevin Stewart » 7 years ago

Kevin Stewart

5 184 0

Any engine using an inductive pick-up is likely to have similar parameters. The amplitude gets larger as the frequency increases. I would rectify the negative pulse, limit the amplitude or block it and then bandpass/lowpass the signal.

I see that someone has done something for the 582 here:

https://hackaday.io/project/21324-modair-rotax-582-engine-interface-module

Thank you said by: RotaxOwner Admin

Report

You do not have permissions to reply to this topic.

Title	Category	Replies
RPM Signal for CSU Prop	912 / 914 Technical Questions	17
Tachometer Calibration = Vital!	General Tech Discussion	1
What is the "Interlane keepalive discrete signal failure" ECU status?	915iS Technical Questions	3
Tachometer Wiring 447 SCDL	2 Stroke Technical Questions	2
Tachometer reading lower RPM than the engine is actually doing	General Tech Discussion	1

Tachometer Signal Characteristics

Recent Videos

Safety First!

Prize Giveaway!

Log In/Out

Login