CAN GND HIC A AND HIC B
in 912iS Technical Questions
8 years ago
For those that have installed a 912iS along with a Dynon EMS Skyview, where are you picking up the CAN GND Pin #4 for HIC A and CAN GND Pin #6 on HIC B?
The CAN HIGH and CAN LOW are picked up from the Dynon EMS connector from pins 36 and 37 but I cannot find a dedicated wire in the Dynon harness for the CAN GND.
I have two maintenance CAN DB9 ports that use the GND from one of the DB9 pins, but this is not from the display port.
I have spoken to Dynon and the tech says he does not know the answer. His only advice is to use the wiring diagram?
I have read that a CAN GND may not be required in many applications.
For those that have installed this system:
1. Which wire did you route to pin #4 on HIC A and pin #6 on HIC B?
Thanks.
The CAN HIGH and CAN LOW are picked up from the Dynon EMS connector from pins 36 and 37 but I cannot find a dedicated wire in the Dynon harness for the CAN GND.
I have two maintenance CAN DB9 ports that use the GND from one of the DB9 pins, but this is not from the display port.
I have spoken to Dynon and the tech says he does not know the answer. His only advice is to use the wiring diagram?
I have read that a CAN GND may not be required in many applications.
For those that have installed this system:
1. Which wire did you route to pin #4 on HIC A and pin #6 on HIC B?
Thanks.
