fbpx

 

For anyone wishing to buy replacement connectors, Identifying the parts is the hard part.
The good new is that no part costs more than $10, and is in Stock at Mouser Electronics.

The HIC parts are Molex MX-150L series.

Do NOT Confuse these with the MX-150 series. (No "L")
They are too small and will not fit! (L = Large ???)

HarnessInterfaceConnectors.pdf (You do not have access to download this file.)

Bill Hertzel
Rotax 912is
North Ridgeville, OH, USA
Clicking the "Thank You" is Always Appreciated by Everyone.

  • Re: Harness Interface Connectors, HICA, HICB, X3

    by » 7 years ago


    Bill, thank you for this valuable information. I'm at the point when I need to start crimping these connectors to my cable assembly. However, the crimping and assembly tools for the X3 connector are very expensive (nearly $1000). At this point I would like to either use a lower cost crimping tool or send it to a vendor so they can crimp it on my AWG 12 cables. Do you or anyone else have any suggestions?

    I am also trying to come up with a crimping option for the HICA and HICB but these seem to be much much less expensive.

    Thanks!

    Bryan

You do not have permissions to reply to this topic.