fbpx

 

Hi all,

Have been having problems with my Rotax 582 for a month now. I am somewhat over the main fuel problems now after doing a rebuild of both carbies and replacing all fuel filters and flushing the lines, and replacing all fuel with fresh. The only thing I haven't done so far is the fuel pump, but before I pull this apart, I seek any help/ideas on what might be causing the following.

I took off in 85 deg OAT last evening and even before I climbed to 1000 feet the engine temp was 185 deg with the EGT's both within range. The left one 1100 and the right 1150. I tried to cool it down at low rpm but could not, so returned to land. The water levels were checked prior to flight.

Any advice welcomed.

Mike
  • Re: 582 high engine temp

    by » 12 years ago


    Mike,

    If the EGTs are normal, it's not a fuel problem. If your 582 is a bluehead, it could be a bad thermostat. You can heat the thermostat in a pot of water on the stove with a meat thermometer and see if it begins to open at the right temperature.

    Bill.

    Thank you said by: Michael Regan

  • Re: 582 high engine temp

    by » 12 years ago


    Never thought of that... thanks bill. I am wondering now if I should try operating without the thermostat at all? Thats what we used to do to the old Ford years ago. I understand that this would of course take longer at warm up, but think the sacrifice might be worth it. Anyway I will try bills idea first, and if it proves it is working properly, I will leave it out, and if it shows faulty, I will replace it. As a matter of interest bill (or others) what would be your normal operating temp at OAT 85deg?


    mike

  • Re: 582 high engine temp

    by » 12 years ago


    I just installed a new 582 Blue head in my airplane. I was running very high engine temps (185+ F.)and I tried everything to get it to run cooler. I did all of the checks for traped air bubble, checked the thermostate and replaced the radiator cap. Flushed the radiators. Nothing seemed to help until I read on the internet about the anti freeze mixture. I was running the recomended 50/50 mix in the engine. What you overlook is that the anti freeze is there to prevent the water from freezing not cooling the engine. I reduced the mixture to a 10% antifreeze and 90% water and that brought the cooling way down. It now runs at 150 to 160 F. If you don't have to worrie about your water freezing you might give it a try.

    Thank you said by: Michael Regan

  • Re: 582 high engine temp

    by » 12 years ago


    George... very interesting. Where I live it never ever gets below freezing temp, so maybe I will try that too. I suppose I should empty and refill again, but I dread the time taken getting all the air locks out. Wish there was a way to stop this happening every time. I wonder if I just "trickle" the water in and see if that works. I do wonder though why rotax recommends 50/50. Will report back when I have the work done and the next flight completed. This could be a week or so though.

  • Re: 582 high engine temp

    by » 12 years ago


    Not sure I would like to run an alloy engine on such a weak anti freeze mix....

    Dont forget one of its main jobs is to keep corrosion at bay...as well as being a coolant,

    I no expert on Rotax coolants but I would have thought its main job is just to transport unwanted heat to the rads and for them to dissipate the heat....and I think to Rotax spec type raises the boiling point,

    Running an engine to cool is a prob as well....as others have said and if it where me I would check out your thermostat....I take it the engine did used to run at normal temps....has the airflow to the rads been altered in anyway.

    Nick.

You do not have permissions to reply to this topic.