oil lines

by William Holloway in 912 / 914 Technical Questions 10 years ago

Trying to setup my new 912 using the 332-8 aeroquip hose (1/2") and slip on fitting that came with the engine from the dealer. The problem is that I can't get the hose on to the fittings. The fittings are the correct ones for the oil cooler, tank & suction for the oil pump. What am I doing wrong? Is this the correct hose to be using?

Re: oil lines

by Roger Lee » 10 years ago

Roger Lee

128 5.28k 4.98k

1/2" (13mm) is the correct size. Some hose like Aeroquip has no give and it was designed for a specified fitting type. Some just push it over a barbed fitting. On your oil tank the flared end on the oil tank fitting make make it a little harder to push on. Try some universal lube, "spit" on it and try again. It will fit, but may be a little snug. If the hose is cold warm it up first with a heat gun and try again.

Roger Lee
LSRM-A & Rotax Instructor & Rotax IRC
Tucson, AZ Ryan Airfield (KRYN)
520-349-7056 Cell

Thank you said by: William Holloway

Report
Re: oil lines

by Przemysław Wiśniewski » 10 years ago

Przemysław Wiśniewski

65 247 3

I had problem with this. You should warm up hoses, lubricate them. In hard cases I used a piece of hard plastic foil to fit hose. I made cone on fitting, lubricate it and it's helps me to slide hose on fitting. You have to remove foil after.

Report

You do not have permissions to reply to this topic.

Title	Category	Replies
Air Ingress at Oil Change	912 / 914 Technical Questions	1
Belly Oil	912 / 914 Technical Questions	7
What material is the oil tank lid made of?	912 / 914 Technical Questions	6
Oil line plug caps	General Tech Discussion	5
Oil Temperature	912 / 914 Technical Questions	5

oil lines

Recent Videos

Safety First!

Prize Giveaway!

Log In/Out

Login