fbpx
Login

 

Jump to Forum..

Leaking carb bowl

in 912 / 914 Technical Questions 9 years ago
During the condition inspection i noticed the LH carb bowl was leaking. So i picked up some new Rotax gaskets and installed. The thing is still leaking. Pulled it apart and found nothing. Has anyone had this problem?

  • Re: Leaking carb bowl

    by » 9 years ago

    Make sure there is no debris in the recessed part of the carb body that the bowl fits into. Make sure the bowl sits squarly down inside that recessed area. I have seen some think the bowl is seated correctly, but it is caught on an edge. Make sure it is the gasket and not another area of the carb or the float height is wrong and the carb is flooding some.

    Roger Lee
    LSRM-A & Rotax Instructor & Rotax IRC
    Tucson, AZ Ryan Airfield (KRYN)
    520-349-7056 Cell

      
    Report

  • Re: Leaking carb bowl

    by » 9 years ago

    I had some gaskets a few years ago that when new would ooze until they "cured" it took about a week for them to quit leaking.
      
    Report

  • Re: Leaking carb bowl

    by » 9 years ago

    Just my personal .02 cents and you may do it differently:

    I don't use the cork gaskets from Bing. I do use the fiber gaskets that you usually get from the Rotax distributors. What I do different is rub them down with white lithium grease especially around the edges. I rub it in well and never leave any globs. I almost never have a carb leak again. I say almost because there was 1-2 times it did re-leak after a short time. Just something I tried and seems to work, but it may not be for everyone.

    Roger Lee
    LSRM-A & Rotax Instructor & Rotax IRC
    Tucson, AZ Ryan Airfield (KRYN)
    520-349-7056 Cell

      
    Report

  • Re: Leaking carb bowl

    by » 9 years ago

    They have sat for about a week and a half and it is still seeping. These gaskets are the fiber not cork. I will try the grease and see what comes of it. Thanks
      
    Report

  • Re: Leaking carb bowl

    by » 9 years ago

    There must be a reason this is leaking if it wasn't before.


    I don't use the lithium on a used gasket. I only do this on new unused. Too late if it's used. You need to find out why it is still leaking. I did have some trouble a few years back and ask Bing about trying a cork (thinner) and a fiber (thicker) gasket together. They didn't seem to have any issues with this. Two fiber gaskets are too thick.

    Roger Lee
    LSRM-A & Rotax Instructor & Rotax IRC
    Tucson, AZ Ryan Airfield (KRYN)
    520-349-7056 Cell

      
    Report
You do not have permissions to reply to this topic.
Related Topics
Title Category Replies
Carb sync varies over throttle range 912 / 914 Technical Questions 5
No 912uls carbs in US?! Rotax-Owner Community 1
New carb socket fits loose 912 / 914 Technical Questions 67
Engine will not make power after carb install, post-overhaul General Tech Discussion 42
Carburetor Piston Wear 912 / 914 Technical Questions 8
Follow Us

Recent Videos

Safety First!

 

To receive critical-to-safety information on your ROTAX Engine, please subscribe to
ROTAX-OWNER.COM

Prize Giveaway!


SUBSCRIBE NOW
to automatically enter this years draw!

Login