Bracket and stator pickup

by jay white in 912 / 914 Technical Questions 7 years ago

This picture is of the back of my new engine. The Clamp holding the braided bundle is apparently part of the pick up assembly. If I take off the clamp to relocate the modules will I disturb the pick up? I thought they were a fixed position. So, If I'm wrong, the gap for the pick up will be disturbed. I don't really want to create an electrical problem.

DSC_0156.JPG (You do not have access to download this file.)

Re: Bracket and stator pickup

by Bill Hertzel » 7 years ago

Bill Hertzel

13 1.95k 7.98k

If you are careful, it should not change the adjustment.
Be sure the bolt on the other wing is secure before loosening the clamp.
Check the Gap afterward.

This isn't much harder than replacing a spark plug.

In any case, this is not something you should be afraid of adjusting.
With the Trigger Cam rotated under the Coil, Placing 0.012 feeler gauge between the Coil and the Cam and pressing Down and Clockwise will set the position while you tighten the screws.

See Section 74 Of the Heavy Maintenence Manual.

Bill Hertzel
Rotax 912is
North Ridgeville, OH, USA
Clicking the "Thank You" is Always Appreciated by Everyone.

Thank you said by: jay white

Report

You do not have permissions to reply to this topic.

Title	Category	Replies
Stator/Mag Ring Puller	912 / 914 Technical Questions	6
912iS Stator Failures	912iS Technical Questions	3
912iS Stator Failures	912iS Technical Questions	0
Float suspension brackets	912 / 914 Technical Questions	14
914 Tach Pickup	912 / 914 Technical Questions	2

Bracket and stator pickup

Recent Videos

Safety First!

Prize Giveaway!

Log In/Out

Login