fbpx

 

  • Re: CAN bit definition- warning lamps

    by » 4 years ago


    Yes same report, i am referring. 

     

    What is the difference between warning lamp bit and state in CAN protocol:

    *Lane A Warning Lamp Bit (1 bit information) on Lane A (CAN ID 1508) has been cross shared on Lane B (CAN ID 1512)

    *Lane A Warning Lamp State (2 bits information) on Lane A (CAN ID 556). Definition is 

    0x0 = Warning Lamp Off0x1 = Warning Lamp Flashing0x2 = Warning Lamp On


  • Re: CAN bit definition- warning lamps

    by » 4 years ago


    Pilot Joe wrote:

    The installation manual for the iS says to contact an authorized service center for the document.

    [[   REDACTED by forum administrator  ]]

    Disclaimer: The authorization document says it is valid until the 31st of December, 2019. If this means ASK INC is no longer authorized to distribute the specifications document (which is dated 2017), please tell me and I will remove the link from this post.

    Yes, please do not share distributor-level and proprietary information on the public web forums.

    If in doubt, please contact info@rotaxowner.com before posting any document! 


  • Re: CAN bit definition- warning lamps

    by » 4 years ago


    Ramanathan SG wrote:

    Yes same report, i am referring. 

    What is the difference between warning lamp bit and state in CAN protocol:

    *Lane A Warning Lamp Bit (1 bit information) on Lane A (CAN ID 1508) has been cross shared on Lane B (CAN ID 1512)

    *Lane A Warning Lamp State (2 bits information) on Lane A (CAN ID 556). Definition is 

    0x0 = Warning Lamp Off0x1 = Warning Lamp Flashing0x2 = Warning Lamp On

    @Ramanathan SG : The kind of information you are requesting is restricted to factory-trained iRMT specialists and authorized OEMs (and usually only delivered under non-disclosure agreements!) . This is to promote safety, as not to encourage unqualified individuals attempting to interface or modify these complex and carefully tuned products. 

    PLEASE MAKE THESE ENQUIRIES DIRECTLY TO YOUR REGIONAL DISTRIBUTOR: https://dealerlocator.flyrotax.com/

     


  • Re: CAN bit definition- warning lamps

    by » 4 years ago


    RotaxOwner Admin wrote:
    Pilot Joe wrote:

    The installation manual for the iS says to contact an authorized service center for the document.

    [[   REDACTED by forum administrator  ]]

    Disclaimer: The authorization document says it is valid until the 31st of December, 2019. If this means ASK INC is no longer authorized to distribute the specifications document (which is dated 2017), please tell me and I will remove the link from this post.

    Yes, please do not share distributor-level and proprietary information on the public web forums.

    If in doubt, please contact info@rotaxowner.com before posting any document! 

    OK, sorry about that. It was released by an authorized distributor so I had assumed that they had permission. I'll contact the email next time to make sure before posting other documents.


    Thank you said by: RotaxOwner Admin

You do not have permissions to reply to this topic.