Login

Increased RPM at take off speed or slippage?

by william schuller in General Tech Discussion 10 years ago

Page 4 of 4

Start
Prev
1
2
3
4
Next
End

Re: Increased RPM at take off speed or slippage?

by Rob Seaton » 10 years ago

Rob Seaton

3 1.32k 251

Did you find a replacement clutch William?
Or cleaned up and re-set the original?

Report
Re: Increased RPM at take off speed or slippage?

by Rhett Mitchell » 10 years ago

Rhett Mitchell

8 99 0

Has moly or any friction modifier oil ever been used? That would explain why the clutch is slipping.
I would replace the clutch, if the moly is embedded in the sintered bronze or steel discs I doubt any amount of cleaning will get it out.

I'm interested in what oil has been used too.

Report
Re: Increased RPM at take off speed or slippage?

by Donald Cameron » 6 years ago

Donald Cameron

0 1 0

Interested to find out if there was ever any resolution to this issue? I have experienced very similar problems and looking to find the solution?

Report

Page 4 of 4

Start
Prev
1
2
3
4
Next
End

You do not have permissions to reply to this topic.

Related Topics

Title	Category	Replies
912is low fuel pressure (in-flight only) under 3500 RPM	912iS Technical Questions	7
Red X through RPM or other	912iS Technical Questions	6
915is > 250 RPM drop on lane check	915iS Technical Questions	1
RPM issue, first start, new engine	912 / 914 Technical Questions	8
914 throttle lag, mag rpm drop	912 / 914 Technical Questions	4

Top

© Rotax-Owner.com

Login