fbpx
Login

 

Jump to Forum..

Oil Pressure valve

in General Tech Discussion 9 years ago

  • Re: Oil Pressure valve

    by » 9 years ago

    Roger,

    I'm new to the forum...just setting my new engine up (hasn't been started yet) having found that carb floats need to be replaced due to recall. I would like to convert (at the same time) to the mushroom oil pressure relief set up. Would you direct me or post required part numbers to effect change. Thanks..

    Ric

    Edit: sorry..it's a 912uls in a RV-12 e-lsa
      
    Report

  • Re: Oil Pressure valve

    by » 9 years ago

    Hi Ric,

    Since this is a new engine I'm pretty sure you have the new style plug screw with the hollowed out hex head center. Your engine is new so no use in replacing the spring. So the only part you need is the mushroom to replace the ball bearing. The Part number for that is
    857-230.
    When you install it the dry thread torque value on the plug screw is 25nm (19ft/lbs or 228 in/lbs). If there is oil on the threads then the wet torque is 11.2 ft/lbs (135 in/lbs).

    Hope this helps.

    Roger Lee
    LSRM-A & Rotax Instructor & Rotax IRC
    Tucson, AZ Ryan Airfield (KRYN)
    520-349-7056 Cell

      
    Report
You do not have permissions to reply to this topic.
Related Topics
Title Category Replies
Tightening oil return line fittings 915iS Technical Questions 2
Pressure Purge with Hydraulic Governor 915iS Technical Questions 1
Drain Gear Box during oil change? 912iS Technical Questions 3
Fuel pressure regulator - $400 from Rotax or $22 online 912iS Technical Questions 18
Oil return line fitting leak 912 / 914 Technical Questions 12
Follow Us

Recent Videos

Safety First!

 

To receive critical-to-safety information on your ROTAX Engine, please subscribe to
ROTAX-OWNER.COM

Prize Giveaway!


SUBSCRIBE NOW
to automatically enter this years draw!

Login