Login

AN fuel hoses for 914

by Ken Ryan in 912 / 914 Technical Questions 7 years ago

Page 2 of 2

Start
Prev
1
2
Next
End

Re: AN fuel hoses for 914

by Ken Ryan » 7 years ago

Ken Ryan

28 360 928

Thanks. I think I get it. I did finally find the appropriate banjo, but it is aluminum. I found it at Summit Racing. It is manufactured by Vibrant Performance. Here's the link:

https://www.summitracing.com/parts/vpe-11520/overview/

Report
Re: AN fuel hoses for 914

by Bill Hertzel » 7 years ago

Bill Hertzel

13 1.95k 7.97k

Good Deal. I think I get it too!
You are not going to give up your Banjoes. :)

There are many options once you know where to look.
Bill.

Bill Hertzel
Rotax 912is
North Ridgeville, OH, USA
Clicking the "Thank You" is Always Appreciated by Everyone.

Report
Re: AN fuel hoses for 914

by Ken Ryan » 7 years ago

Ken Ryan

28 360 928

Actually Bill, I don't think I will go with aluminum on the engine. If I were to use the existing hose barbs, is there a hose that I could use that is not subject to the 5 year rubber regimen?

Report
Re: AN fuel hoses for 914

by Bill Hertzel » 7 years ago

Bill Hertzel

13 1.95k 7.97k

There are hoses with Teflon inner liners, but the outer jacket is still rubber.
No matter what, rubber does not find an engine compartment to be a friendly place.
Just keep inspecting them early and often.

All my AN6 fittings on the engine are steel.
The hose ends are aluminum, however.

Bill Hertzel
Rotax 912is
North Ridgeville, OH, USA
Clicking the "Thank You" is Always Appreciated by Everyone.

Report

Page 2 of 2

Start
Prev
1
2
Next
End

You do not have permissions to reply to this topic.

Related Topics

Title	Category	Replies
"High" fuel pressure alerts	915iS Technical Questions	1
Low fuel pressure	912 / 914 Technical Questions	7
Fuel Hoses	912 / 914 Technical Questions	27
914 very intermittent partial power loss	912 / 914 Technical Questions	5
Fuel System Pressure Testing before engine start	General Tech Discussion	1

Top

© Rotax-Owner.com

Login