914 Turbo Servo problem

by Eric Dussault in 912 / 914 Technical Questions 9 years ago

Seems like I have an issue with my wastegate servo motor on my 914. It was working properly till today. Yesterday I worked on the plane and flipped the tcu switch off in order to avoid the controller to work while I was doing some electrical work in the panel with the master on. Today before starting the plane I flipped the TCU on before starting the engine and everything seemed fine for few minutes then I seen the turbo light flashing so I went back to the dock (on floats) to make some test just to realize the servo barely move when I flip the master on. The plane/engine has 110hrs, Is that common to change the servo motor?? I thought it was more sturdy than that. Is there any fix or I need to order a new part?

Thanks.

Eric.

Page 1 of 2

Start
Prev
1
2
Next
End

Re: 914 Turbo Servo problem

by Rob Seaton » 9 years ago

Rob Seaton

3 1.32k 251

make sure the cable is not wrapped up or kinked. Then test it again making sure the TCU switch is ON and the throttle is at idle before turning on your master switch.
you should not have to replace the servo, that would be very unusual as they are very durable.

Thank you said by: JUAN ESTEBAN ARIZA

Report
Re: 914 Turbo Servo problem

by Eric Dussault » 9 years ago

Eric Dussault

3 11 0

Thank you Rob,

You may be right, when I put the master on I can hear the servo making noise and move just a bit but I cannot see where the cable could be jammed or kinked. I tried to force it to move with my fingers and can have it to cycle with help so I thought the motor could be tired and not powerful enough to pull the spring on the waste gate. I may try to replace the cable at first thing.

Thank you said by: JUAN ESTEBAN ARIZA

Report
Re: 914 Turbo Servo problem

by Rob Seaton » 9 years ago

Rob Seaton

3 1.32k 251

try removing the cable and see if it makes its proper cycle, approximately 100 degrees of travel. (from the 8:00 o'clock position to the 12:00 o'clock position and then return to the 8:00 o'clock position)

Report
Re: 914 Turbo Servo problem

by Capt. Siva, » 7 years ago

Capt. Siva,

25 266 738

can any explain the servomotor for 914 engine life? when it required to replace? or servo motor replace with TBO?

Report
Re: 914 Turbo Servo problem

by Rob Seaton » 7 years ago

Rob Seaton

3 1.32k 251

It is an on-condition component.
The servo is checked at overhaul but not replaced unless it fails the test.

Thank you said by: Capt. Siva,

Report

Page 1 of 2

Start
Prev
1
2
Next
End

You do not have permissions to reply to this topic.

Title	Category	Replies
problem after changing tanks	912 / 914 Technical Questions	2
914 turbo overboost/crankshaft distortion symptoms?	912 / 914 Technical Questions	2
914UL Turbocharger	912 / 914 Technical Questions	2
914 Fuel Pressure/Prop Pitch	912 / 914 Technical Questions	2
ROTAX 914 fuel pumps	912 / 914 Technical Questions	1

914 Turbo Servo problem

Recent Videos

Safety First!

Prize Giveaway!

Log In/Out

Login