912iS Shunt Regulator Experiment

Griploc Ties are a good solution too.  I find them a lot easier to use than Adel clamps.

https://griplockties.com/

Eric and Bob,

The factory did use some nylon ties around the engine mount and I have replaced them when needed.  In most areas they used small sections of rubber hose as standoffs, but the nylon still contacts the engine mount.  I never thought much about it but what you say makes sense.  I may need a combination of the products you each suggested to correct this.  I like the griplock reusable ties, I’ve never seen those before.  I’ve used clamps similar to the Adel clamps, but the silicone lining is definitely a plus. Thank you both for your suggestions.