912iS installed in an RV-12iS. About 270 hours
Data point is only in cold weather, so don't know if temp has an effect on the problem below.
Upon start, no generator amps present. Increasing RPM to ~ 2400_ish, Gen B comes on-line as it normally does.
I'll run the engine for a couple minutes, shut down, restart - Then Gen A is on line at the beginning and then Gen B comes on-line at about 2400 RPM.
To summarize: Gen A doesn't come on-line at initial startup, but does come online after a bit of warmup/shutdown/restart.
All other elec seems to be normal.
Thoughts from the brain trust??
Thanks Much!!
MikeB
