Login

912iS ECU / BUDS Dongle Connection Failure

by Hafeez Ahmed in 912iS Technical Questions 11 years ago

Page 2 of 2

Start
Prev
1
2
Next
End

Re: 912iS ECU / BUDS Dongle Connection Failure

by Hafeez Ahmed » 11 years ago

Hafeez Ahmed

1 21 0

I have not installed any extra resistor between pin 2 & 7. I will measure internal resistance between these pins and let you inform later.

Once I off / On the lane switches, all parameters becomes correct and fine running of engine.

Report
Re: 912iS ECU / BUDS Dongle Connection Failure

by Rob Seaton » 11 years ago

Rob Seaton

3 1.32k 251

Are you using a "rotary" switch for the lanes and start function?

Report
Re: 912iS ECU / BUDS Dongle Connection Failure

by Hafeez Ahmed » 11 years ago

Hafeez Ahmed

1 21 0

Hi Rob Seaton,

I am not using a rotary switch for lanes and start, I am using separate toggle switches for Lanes and a push button switch for Start.

Report
Re: 912iS ECU / BUDS Dongle Connection Failure

by Rob Seaton » 11 years ago

Rob Seaton

3 1.32k 251

what about the "start power switch"? is it a momentary toggle double pole single throw DPST(M)?

Report
Re: 912iS ECU / BUDS Dongle Connection Failure

by Hafeez Ahmed » 11 years ago

Hafeez Ahmed

1 21 0

No Rob, It is Simple DPDT Switch, but I use this Switch ''ON'' Only for the time of Engine Start

Report

Page 2 of 2

Start
Prev
1
2
Next
End

You do not have permissions to reply to this topic.

Related Topics

Title	Category	Replies
BUDS 4.1.0 Not connecting.	912iS Technical Questions	6
BUDS available for rent?	912iS Technical Questions	3
Wanted to Buy--BUDS 3	Tools	3
New 912iSc Crank Bias Negative Voltage	912iS Technical Questions	2
912is low fuel pressure (in-flight only) under 3500 RPM	912iS Technical Questions	7

Top

© Rotax-Owner.com

Login